Several months of testing and several design modifications resulted in a product of the highest quality.
We present a stable and carefully finished rim stand. A tool used to support work on rims or entire wheels. Thanks to 3 rollers, we can easily turn the wheel in any direction. The rollers can be set at an angle by supporting the wheel on the handlebar, or horizontally without using the handlebar. This solution allows you to work on the rim according to your preferences and capabilities.
The stand is made of high quality, durable 4mm black steel, precisely cut and bent, and finally coated with a powder-coated finish, both inside and out, to provide an additional layer of protection against oxidation.
The lower rollers are 300 mm long and the upper one is 400 mm long (total headband length 900 mm) and will fit rims from 14" to 22". High-quality rubber feet will keep the stand in one position during the entire work. Thanks to special rear bends, the headband is very stable even with massive wheels.
The stand is perfect for:
- application of ceramic coating
- rim renovation
- polishing rims
- painting rims
- cleaning rims
Dimensions:
- Length – 59 cm
- Width from the wall – 37 cm
- Height – 92 cm
The powder protective layer is resistant to moderate water pouring, but if part of the protective layer is damaged, the steel may corrode. Therefore, we do not recommend pouring a lot of water on the stand, and after any flooding, it should be dried thoroughly.





Reviews
There are no reviews yet.